Why do you need to adjust woodworking routers?

Also known as a bit, you can adjust the height of a router cutter for cutting to control how deep you’re going to cut into a given material. There are various applications.

You could change the router if you want to reach a specific depth or you have to do the same thing but on multiple positions. When you adjust the height, you’re able to determine how much material gets removed with every pass that you make.

wood router tips

If your router is in hand-held mode, then height here refers to just how far below the base plate the cutter itself sticks out. Those with a router table it relates to how far above the tabletop the router sticks out.

In changing the cut, you’re also not just able to tell about the depth. You can also use it to dictate the way the cut appears. It is also in adjusting the height that you can get intricate cuts, for example, to get flat-bottomed grooves.

How to set the depth of a woodworking router

Easy-Adjust Router Trammel Woodworking Plan

There are various kinds of woodworking routers. There is a fixed base router, for example. Once you set the height, the cuts are consistent throughout. For the plunge router, there is more accurate depth selection thanks to merely changing the height.

You can also lock it in position at any point. In the market, you’ll find that there are plunge routers that have three- turret position stops. That means you can set three different cutting depths quickly as you work.

You will want to settle for an industry-grade woodworking router if you’re going to get that exceptional precision as you’re adjusting the cutter. You do, however, have to note that the router height adjustment varies depending on the model you’re using.

The best way to know what works is to check out the manuals that each of the power tools comes with. Alternatively, you can make shallow passes if you’re unsure until you get to the depth you’re looking for. That is what is known as progressive cuts.

Pro tip: to avoid accidents, ensure that the router is off before making adjustments.

How to set the three-position turret stop on a router

Adjusting the cutting depth on a router

The purpose of the three-position turret is to so that you’re able to pre-set three cutting depths. You want that because it is useful when it comes to making repetitive deep cutting while using progressive cuts.

There is that, or when also making cuts of different depth in the same workpiece. The good thing about it is you can change the depths of the cuts quickly while you’re working.

How do you adjust the heights of the turrets stop themselves? That’s simple. All you have to do is loosen the locking nuts, then you raise them, or you lower the screws, and then you tighten them back into place.

The deep cut refers to the distance between the top of the turret stop, and the bottom of the depth stop rod. The lowest screw will have the deepest cut wanted. For progressive cuts, set the stops are required.

Ever wondered how pro woodworkers make angle cuts with a table saw?

Summary

Let’s now look at a quick guide summary on how to ensure that you get the perfect cut. You start by ensuring that the cutter touches the surface of the workpiece. From there, release the depth stop. Drop it so now it rests on the stop that is right below it. As mentioned, this will be one of the three turret stops that were discussed earlier in the article.

Next, you’re going to set the depth of the router cutter. You start by raising the depth and then you’re to match it to the cut that you want. After, lock the depth stop in the place so that you have the maximum cutter depth.

Any time that you make the plunge motion, you’ll find that it’s been locked at its depth. Once you’ve set the turret stops you can then start cutting into the material in question. You’ll find that the turret stops rotate, making it easy to switch between them. With that, you’re able to make the ideal flawless dadoes and rabbets, precision pattern cutting and edge profiles.

 

 

Leave a Comment

67 − 65 =